Industrial PC requirements are far different from the need for office computers. Industrial computer needs will also vary dramatically depending on the industry itself. Computers used in food manufacturing may have to be waterproof and sealed intrinsically to prevent explosions in the atmosphere that potentially explode and dusty while also made of stainless steel or materials that are easy to clean. But the computer in the heavy industry may also have to protect from dust and dirt but can withstand excessive temperatures, beats and vibrations.
Fortunately there are several options available for industrial computing.
If the industrial area is dusty but there are fewer other dangers mentioned, the cheap solution is to use a conventional office PC equipped with a protective dust cover. Although not designed for the environment with thick dust and dirt, for moderate dusty areas that can increase sufficient protection and can protect the keyboard from dust and liquid, prevent sticky keys (and many unwanted typos errors). Waterproof / dustproof keyboard and other peripherals (such as mouse) are also available. This cover and peripherals are only advised to be used with conventional PCs in areas that are only a little dusty / moist and not the atmosphere full of dust. Some protective coverings offer waterproof limited to areas where there is a risk of light splashes but they are not suitable for areas with a large amount of liquid such as wet spaces or areas to be arranged.
Long seen as the only choice for many industrial applications, computer specialist industries can be designed to survive anything. Some intrinsically sealed and fully airtight, allowing machines to be used safely even in a very explosive atmosphere. Others are produced as a solid state (without moving parts) making them rough, allowing computers to hold severe shocks and vibrations.
Some industrial computers are also built with extra cooling which allows them to be used in the most extreme heat while others contain heaters that allow their use in freezers or coolers. However, this industrial computer can be very expensive, even though they can be made bespoke in order to fit the right requirements. Also covered in units, often with special software installed, when they need to repair and improve, an engineer must be called by the possibility of production must stop until the engine returns online. Also, because industrial computers are designed to survive and cannot be enhanced easily, they tend to offer worse performance and fewer choices than conventional PCs, especially because they are usually equipped with technology or technology that has been outdated, in particular. With a computer level exponential level.
Industrial PC Appendix:
A method that is much cheaper but equally effective with industrial computers is to our conventional PC located at an industrial computer cage. This attachment can do the same task with a bespoke industrial machine; Protect PCs from beats, bangs, theft, interference and vibration, waterproofing, protection from the explosive atmosphere, defense of dirt and dirt, while the heating cage and air-conditioned to allow computing in extreme temperatures. This attachment can also be made to add or add to the requirements that are bespoke depending on the needs of individuals.
The main advantage of this cover is that conventional PCs, with conventional software and components, are placed in overseas and can be replaced or repaired at any time – allowing administrators to increase and make the machine remain up. It also allows computer administrators to choose what PCs most suitable for their needs and what software is most efficient to run. Even pcs of budgets can be placed in computer attachments and